initialize SPI1_CS to drive high

Core/Src/gpio.c

@@ -57,7 +57,7 @@ void MX_GPIO_Init(void)
   HAL_GPIO_WritePin(SPI2_CS_GPIO_Port, SPI2_CS_Pin, GPIO_PIN_SET);
 
   /*Configure GPIO pin Output Level */
-  HAL_GPIO_WritePin(SPI1_CS_GPIO_Port, SPI1_CS_Pin, GPIO_PIN_RESET);
+  HAL_GPIO_WritePin(SPI1_CS_GPIO_Port, SPI1_CS_Pin, GPIO_PIN_SET);
 
   /*Configure GPIO pin : PtPin */
   GPIO_InitStruct.Pin = BME280_PWR_Pin;

hothouse-mon.ioc

@@ -61,9 +61,10 @@ PA13.Mode=Serial_Wire
 PA13.Signal=SYS_JTMS-SWDIO
 PA14.Mode=Serial_Wire
 PA14.Signal=SYS_JTCK-SWCLK
-PA15.GPIOParameters=GPIO_Label
+PA15.GPIOParameters=PinState,GPIO_Label
 PA15.GPIO_Label=SPI1_CS
 PA15.Locked=true
+PA15.PinState=GPIO_PIN_SET
 PA15.Signal=GPIO_Output
 PB12.GPIOParameters=GPIO_Speed,PinState,GPIO_Label
 PB12.GPIO_Label=SPI2_CS
@@ -127,7 +128,7 @@ ProjectManager.StackSize=0x400
 ProjectManager.TargetToolchain=STM32CubeIDE
 ProjectManager.ToolChainLocation=
 ProjectManager.UnderRoot=true
-ProjectManager.functionlistsort=1-SystemClock_Config-RCC-false-HAL-false,2-MX_GPIO_Init-GPIO-false-HAL-true,3-MX_SPI2_Init-SPI2-false-HAL-true,4-MX_USB_DEVICE_Init-USB_DEVICE-false-HAL-false
+ProjectManager.functionlistsort=1-SystemClock_Config-RCC-false-HAL-false,2-MX_GPIO_Init-GPIO-false-HAL-true,3-MX_SPI2_Init-SPI2-false-HAL-true,4-MX_USB_DEVICE_Init-USB_DEVICE-false-HAL-false,5-MX_SPI1_Init-SPI1-false-HAL-true
 RCC.48MHZClocksFreq_Value=48000000
 RCC.AHBFreq_Value=72000000
 RCC.APB1CLKDivider=RCC_HCLK_DIV2