@ -42,6 +42,9 @@ If the transport stream is via UDP, null packets will be transmitted when no dat
@@ -42,6 +42,9 @@ If the transport stream is via UDP, null packets will be transmitted when no dat
Average total power in dB relative to a ±1.0 amplitude signal generated in the pass band.
The modulated signal's level doesn't depend on the symbol rate (or the samples per symbol): it's -3 dB of full scale for QPSK, and -6 dB for BPSK,
8PSK, 16APSK and 32APSK, whose peaks are higher. That leaves room for the pulse shaping's peaks, at any roll-off, and anything beyond full scale is clipped.
<h3>5: Channel mute</h3>
Use this button to toggle mute for this channel. The radio waves on the icon are toggled on (active) and off (muted) accordingly. Default is channel active.
@ -161,11 +164,25 @@ This slider can be used to randomly set the current position in the file when fi
@@ -161,11 +164,25 @@ This slider can be used to randomly set the current position in the file when fi
An MPEG transport stream file can be created from a video file using ffmpeg:
The transport stream should have a constant rate, set with `-muxrate` in bits per second, equal to (or a little below) the DVB data rate (3) for the settings it will be transmitted with.
The example's 691176 is the data rate for DVB-S, QPSK, code rate 1/2 at 0.75 MSym/s.
ffmpeg then pads the stream with null packets to that rate, and the timing in the stream (its PCRs) matches the rate the modulator transmits it at.
Without `-muxrate`, ffmpeg creates a variable rate stream: its rate follows the video encoder's, which over a few seconds can be several times higher or lower than its average, even with `-maxrate`, which can cause choppy audio or video.
The video and audio bitrates, plus 10 to 15% for the transport stream's overheads, must be less than the `-muxrate`.
Set the video encoder's `-maxrate` to limit its peak rate, with `-bufsize` (the video buffer it's measured over) about the same value (around a second's worth): a much smaller buffer reduces the picture quality.
A "dts <pcr,TSisinvalid"warningfromffmpegmeansthevideoandaudioratesneedlowering.
To stream from a video camera via UDP (on Windows):
When streaming via UDP, set the URL's `bitrate` to the same value as `-muxrate`, so ffmpeg sends the packets at a steady rate.
Here, both are set a little (about 2%) below the DVB data rate, so that differences between the PC's and the SDR's clocks don't build up a backlog of packets in the modulator: it transmits null packets whenever it has nothing else to send.